Package: Tek_7404_1_yr_VER_IEEE_9500B_2HD.mcz
Become a MET/SUPPORT Gold Member to download this package!

Procedures in Package

Click on the procedure names to find out details about the procedure files containing them.

Tek TDS7404:(1 year) VER IEEE /9500B 2HD:1.00, Revision: 1

Details about Procedure Files

Below is a list of procedure files (.pro files) in the package.

Subprocedures and procedures files that only contain subprocedures have been excluded.

The references of the subprocedure files have been included.

Tek TDS7404:(1 year) VER IEEE /9500B 2HD:1.00

Date: 2001-11-29

Revision: 1

Automated Reference: Datron 9500

Automated Reference: Datron 9510

Automated Reference: Fluke 9560

Procedure ID No: 01331JC03

Models covered: 7404

Source: TDS 7000Series Performance Verification manual

071-0898-00 June 21,2001

Source Author: Tektronix

Compatibility: MET/CAL 6.11 or later

Subprocedures: Sub Tek 7404 DC VOLTAGE MEAS I 9500:1.01

Sub Tek 7404 BANDWIDTH MEAS I 9500:1.01

Sub Tek 7404 TRIG LEVEL I 9500:1.01

Sub Tek 7404 TRIG CHECK I 9500:1.01

Sub Tek 7404 DELTA TIME CHECK I 9500:1.01

Sub Tek 7404 CROSSTALK CHECK I 9500:1.01

Required Files: None

............

Additional equipment Reqd:

3 x SMA 50 Ohm terminators

BNC(m) to SMA(m) cable

2 x short BNC(m) to BNC(m) cables

Power splitter with SMA(f) to BNC(m) adaptor

50 Ohm BNC feedthrough terminator

Counter Timer 25MHz, 1s gate (e.g. Advantest R5360)

............

The Procedure was tested using:

Model No 7404

Serial No B010298

Options 2M, J2

Firmware Rev 1.3.0

The average run time during testing was 60 minutes.

The procedure is intended for use with Met/Cal(r) calibration software,

and the terms and conditions set forth in your METCAL license apply to

this procedure.

Due to our policy of continuously up dating our products, this procedure

may contain minor differences in specification to those found in the manual

or other documentation. While every effort has been made to ensure that

this procedure is accurate, Fluke cannot be held responsible for the

consequences of error or omissions found within this procedure.

The copyright in this procedure is owned by Fluke Precision Measurement

Limited.

............