Package: rs_fsq8_1yr_ver_lpnx_4419_lfctr_swpg_uwsg.mcz
Become a MET/SUPPORT Gold Member to download this package!

Details about Procedure Files

Below is a list of procedure files (.pro files) in the package.

Subprocedures and procedures files that only contain subprocedures have been excluded.

The references of the subprocedure files have been included.

R&S FSQ8: (1 yr) CAL VER /LPNX,4419,LFCTR,SWPG,UWSG

Date: 2011-03-03

Revision: 1.1

Automated Reference: Agilent E4419B

Automated Reference: Fluke 9640A

Automated Reference: Fluke 9640A-50

Automated Reference: Fluke 9640A-LPNX

Automated Reference: HP 8485A

Automated Reference: LF Counter

Automated Reference: Low Frequency Counter

Automated Reference: Microwave Sig Gen

Automated Reference: Sweep Generator

Automated Reference: µW Signal Generator

Manual Reference: Agilent 11667B

Model(s) Covered:

FSQ8

Source(s):

R&S® Service Manual Instrument, Signal Analyzer, R&S® FSQ3,

R&S® FSQ8, R&S® FSQ26, R&S® FSQ31, R&S® FSQ40, Part No.

1155.5047.82-08-

R&S® Signal Analyzer Specifications, Version 10.00, July 2010

Compatibility:

MET/CAL 7.3.26 or later

Flexible Standard(s) Required:

Synthesized Sweep Generator (SWPG):

Frequency Range: 10 MHz to 16 GHz, CW

Accuracy: ±0.02% (Internal); External Reference capable

Amplitude Range: -40 dBm to +16 dBm

Resolution: 0.02 dB

SSB Phase Noise: <-80 dBc/Hz @ 50 kHz offset

Example: HP 83630B or equivalent

µW Signal Generator (UWSG):

Frequency Range: 10 MHz to 8 GHz, CW

Accuracy: ±0.02% (Internal); External Reference capable

Amplitude Range: -40 dBm to +16 dBm

Resolution: 0.02 dB

SSB Phase Noise: <-80 dBc/Hz @ 50 kHz offset

Example: Anritsu MG3694B or equivalent

LF Counter (LFCTR):

Ch. A Frequency Range: 10 MHz

Accuracy: Based on external frequency standard

Example: Fluke PM 6690/6xx or equivalent

Frequency Standard:

Frequency Range: Suitable for use with configured LF counter

Accuracy: ±0.025 ppm or better (standard)

±0.0075 ppm or better (Option FSU-B4)

Additional Equipment Required:

See "Sub FSQ Add'l Equipment Minimum Use Requirements" for specific

equipment, adapters, and cables required.

The average run times during testing were:

1 hr., 45 min.